Cart 0

Laser Power Supply

Laser Power Supply

60W Laser Power Supply adopts high quality components for major parts to avoid the error in future and strengthen lifetime.

Product ID: 588 Category: .

Laser Power Supply

60W Laser Power Supply adopts high quality components for major parts to avoid the error in future and strengthen lifetime. 60 watts laser power source was widely used to 40W – 70W CO2 laser tube, the main advantage is high frequency, response quickly, less volume, less weight, easy operation, complete protecting function, very good compatibility and effectively protect laser tube and laser power supply lifetime.

The main features of the 60W laser power supply:1. The main features of the 60W laser power supply:

  • Stable performance:
    Each power supply have been much more rigorous testing procedures, under full load high temperature (52~55 degrees celsius) 24 hours of aging, to ensure the stability of each power supply.
  • Good compatibility:
    can adapt to a number of manufacturers of 60W, 50W, 40WCO2 laser tube also has a strong adaptability and fast response, engraving, cutting advantages of good effect.
  • Control is simple:
    Select high or low level control, the use of TTL-level control of the laser can start and stop. At the same time increase the protection switch, testing is through the external water and ventilation.
    Laser power control is simple, you can use 0 ~ 5V analog signal control the size of the laser power, you can also use the PWM (pulse width modulation) signal to be controlled.
  • Protection function:
    Power supply itself has open circuit protection, a good grounding in the case of protection, the power supply to short-term work in the open state, so to avoid the laser tube burst due to the damage caused by laser power supply, thereby enhancing the laser power supply of life.
  • Special Features: (optional addition)
    Power users do not need to open the shell, you can simply determine the laser power is working to distinguish between the failure of laser tube or power supply failure.

Specifications:

Model

Parameters

60W Laser power

Input

Input Voltage

AC220V±10% (Need  AC110V products, ordering need indicate)

AC frequency

47 – 440HZ

Cold-state Surge Current

≤60A(AC220V input)

≤30A(AC110V input)

Leakage current

≤0.7mA(AC220V input)

≤0.4mA(AC110V input)

Output

Maximum output voltage

DC35KV

Maximum output current

DC23mA(depending on the laser tubes of different manufacturers)

Efficiency

≥90%(Full load)

Response speed

≤ 1ms

Control Interface

TTL multilevel switching control, effective level can be high and low selection (see control wiring diagram)

Insulation

Input–output

AC 1500V 1 minutes ≤10 mA

Input–shell

AC 1500V 1 minutes ≤10 mA

Output–shell

Connection

Insulation Resistance

≥50MΩ(DC500V)

Environmental
Requested

Working temperature

-10℃ – 50℃

Storage of temperature

-20℃ – 75℃

Relative Humidity

Maximum 85% RH (non-condensing)

Altitude

100,000 feet of work 
200,000 feet of storage, does not work

Cooling methods

Forced air cooling (fan cooling

Dimensions (L*W*H)

208mm*173mm*93mm

 

1 review for Laser Power Supply

  • Good product and thanks for installation support.

  • Add a review